The maintenance issue of Gates Triangle Belt XPA2000 rubber drive belt is as follows: if we take out a small part of our own face to cherish the items in our lives, whether they are alive or not. Next, let's talk about the maintenance of rubber drive belts. Rubber synchronization
Its service life is affected by factors such as environmental temperature, gearbox, splashing foreign objects, lubricating oil, belt bending, installation tension, etc.
right
For modern engines, the layout of the engine compartment is compact,
High compression ratio and some models have turbocharged configurations, which can increase the temperature in the engine compartment and make the working environment of the drive belt very harsh. The experiment shows that the service life of the transmission belt increases with the increase of ambient temperature
Sharp decline. Neglecting the hot summer water temperature gauge pointer at your time not only harms your engine acceleration, but also your daily consumption of transmission belts.
The transmission belt has high requirements for the transmission system,
The coplanarity and coaxiality of components on the same transmission plane directly affect the service life of the transmission belt. In the entire transmission plane, only the transmission belt belongs to the rubber component, and any interference between the belt and the component caused by abnormalities in any component is
It will seriously damage the transmission belt. After long-term operation of the gearbox end face, due to wear and other reasons, it is highly likely to damage the homogeneity or coaxiality of the original end face components. Due to the complexity of the driving state of a car, it is highly likely to operate in harsh external conditions
In the driving environment, foreign objects may splash onto the synchronous belt or synchronous belt pulley. When the object is running at high speed, it is like a small knife constantly cutting the belt, which can quickly cause damage to the transmission belt. When driving in harsh environments, promptly
Check if there are any foreign objects splashing into the transmission system! Maintenance Issues of Gates Triangle Belt XPA2000 Rubber Transmission Belt
Similarly, lubricating grease can accelerate the aging process of rubber. Therefore, when demolishing or installing the drive belt, if your hands are stained with oil, please wipe them clean before departure! Please remember not to place the drive belt in
In the oil pollution. If your drive belt accidentally gets stained with oil, please use it with caution and replace it immediately. An important component of the belt, it can cause a decrease in belt tension under small bending radii. Especially the maintenance issue of the XPA2000 rubber drive belt with Gates triangle belt
Regular belt: Due to its curtain being made of fiberglass; Fiberglass, fragile, can cause severe attenuation of belt tension even with small bending radii. Therefore, excessive bending of the synchronous belt is prohibited. as
The fruit peel belt should be wrapped around a round rod to avoid sharp bends in the belt under very small bending radii.
For accessory belts, they use the friction between the two sides of the belt and the pulley to achieve transmission. Therefore, the magnitude of the installation tension will directly affect the usage status of the transmission belt: if the tension is too small, it will cause the belt to slip, which not only exacerbates the wear on both sides of the belt but also accelerates the aging process of the belt due to the accumulation of heat generated by the slip.