Bar screening machine

Aging household waste rod screening equipment, rod screening machine. The aging household waste rod screening machine adopts a double eccentric shaft exciter, which can withstand the impact of large block materials falling and has a large screening capacity. In the production process, it can screen and give out block and granular materials. The special grid design can prevent material blockage. Grid bar ..

The Zhengzhou Zhongcheng aged garbage rod screening equipment is a door shaped rod screening device used for the treatment of aged household waste, including door shaped rods, rod slots, vibration frames, vibrators, slide plates, discharge ports, and guide troughs; The door shaped bar is a whole structure consisting of two bar supports and bar beams, with the bar beams serving as the material screening surface; The vibration frame is a rectangular frame, tilted and equipped with baffles on both sides that are higher than the screening surface of the bar; There are several sets of rod slots on the vibration frame, and the rod supports are fixed on the rod slots to form a whole door shaped rod screen frame; The height of the bar screen support is 40-100cm; the higher end of the door type bar screen is the feeding area, which is equipped with an inclined first chute plate. The lowest point of the first chute plate is located above the screen surface; There is a discharge port below the vibration frame, and a guide groove is located at the bottom of the discharge port. The gate shaped bar in this design is a rectangular gate shaped whole with a wide cross-section, high strength, and the ability to make a longer screen surface.

Gate shaped rod 1 is a door like overall structure composed of two rod supports and rod beams. The rod beam is the receiving screen surface, and the top surface of the rod beam is flat, with a cross-sectional width of 2-8cm. Vibration frame 3 is a rectangular frame, tilted and equipped with baffles on both sides that are higher than the rod screen surface (as shown in the figure); The rod slot 2 is evenly distributed on the two opposite sides of the vibration frame 3 and fixedly connected to the vibration frame 3 (only one rod slot 2 is shown in Figure 1, the rest is omitted). The vibrator is connected to the vibration frame 3, and the two rod support ends of the door shaped rod 1 are respectively connected to the rod slot 2 on opposite sides of the vibration frame 3. Both the rod support end and the rod slot 2 are provided with fixed holes 4 of the same aperture, which are fixed by bolts passing through the fixed holes 4 to form the main structure of the door shaped rod screen. There are several width adjustment modules 5 in the rod slot 2, and the width adjustment modules 5 are provided with fixed holes 4 of the same aperture as the rod slot 2. The fixed hole 4 and the width adjustment module 5 are located between the end of the bar support and the bar slot 2. The thickness of the width adjustment module 5 is in three specifications: 1 cm, 2 cm, and 3 cm. The contact surface between the door shaped bar 1, the width adjustment module 5, and the bar slot 2 is a rough friction surface