CB32107/800 Cement Plant Power Plant Mobile Cable Sliding Line Guide

NegotiableUpdate on 03/21

Model

Nature of the Manufacturer: Producers

Product Category

Place of Origin

Online Consult

Overview

CB32107/800 Cement Plant Power Plant Mobile Cable Sliding Wire Guide Yangzhou Tianxiang Electric Co., Ltd. Many manufacturers are unable to understand the sliding wire standards when purchasing sliding wires, and cannot determine the quality of the purchased sliding wires or whether they meet the actual standards. Next, we will provide a detailed introduction to the industry standards for sliding wires: a customer once asked me if there are national standards for sliding wires. In fact, it mainly consists of two departments, including insulation protection sliding connection transmission devices and rigid sliding wire transmission guide devices.

Product Details

CB32107/800 Cement Plant Power Plant Mobile Cable Sliding Line GuideThis product consists of three main parts: flat cable, four-wheel trolley for carrying cables, and track. Flat cables are made of non combustible materials and can be used both indoors and outdoors, as well as in places that come into contact with oil stains. They have certain weather resistance and advantages such as smaller bending radius and longer lifespan compared to round cables.

Cable sliding line
Model	Track section size (mm)				Suitable for small car models
Model	A	B	C	D	Suitable for small car models
33	33	40	14	2.0	DTC-33
40	40	40	14	2.0	DTC-44
50	50	50	16	2.5	DTC-50
60	63	18	18	4.0	DTC-60
70	72	68	22	4.0	DTC-70
100	100	100	35	6.0	DTC-100
Note: 1. Standard length of track: 4m, 6m. 2. Track materials: cold-rolled steel plate, stainless steel plate

CB32107/800 Cement Plant Power Plant Mobile Cable Sliding Line GuideThe track is the carrier of the cable car. There are both straight sections and curved sections with a radius greater than 500 millimeters. The straight section has a unit length of 4 meters (or 6 meters) and can be extended and lengthened by connecting with a coupler.

The application of C-shaped steel can be said to be quite extensive, not only as purlins and wall beams in steel structure buildings; It can also be self-assembled into lightweight building components such as roof trusses and brackets. Regardless of the purpose, the same issue will be involved, which is the cutting of C-shaped steel. Due to different cutting methods having different cutting effects, it is necessary to make appropriate selections according to customer requirements. In general, when C-shaped steel is applied in steel structures, its cutting should be carried out on shearing machines or sawing machines as much as possible, especially for thin-walled steel roof trusses. The reason for this suggestion is that accurate cutting is required here, and the electric sawing method is suitable. It not only has high efficiency, but also has a smooth and flat cross-section, good quality, and very small cutting errors.

Of course, C-shaped steel can also be cut by gas cutting, but in order to improve the quality of gas cutting, it is better to use small-diameter nozzles and gently tap with a hammer after cutting to make the incision flat and meet the requirements of various uses.