CD-80 electromagnetic pulse valve

CD-80 electromagnetic pulse valve, steel plant electromagnetic pulse valve, Mount Taishan big cover pulse valve seat are embedded in the air chamber, with small resistance, good liquidity, high injection volume, increased load with momentum, and expanded the use range of air source pressure. This submerged pulse valve is more suitable for use in situations with wide air source pressure.

CD-80 electromagnetic pulse valve,Steel plant electromagnetic pulse valve,Mount Taishan Dagai Pulse ValveFor submerged electromagnetic pulse valves (also known as embedded valves), they are directly installed on the distribution box and have the flow characteristics of ____. The pressure loss has decreased, making it suitable for work environments with lower gas source pressure. The submerged electromagnetic pulse valve seat is embedded in the airbag for installation, with low resistance, good circulation, high injection volume, increased load carrying capacity, and expanded range of gas source pressure. This submerged pulse valve is more suitable for use in situations with wide gas source pressure.

CD-80 electromagnetic pulse valve,Steel plant electromagnetic pulse valve,Mount Taishan Dagai Pulse Valveworking principle:

The diaphragm divides the electromagnetic pulse valve into two chambers, front and rear. When compressed air is connected, the compressed air enters the rear chamber through the throttle hole. At this time, the pressure in the rear chamber presses the diaphragm assembly tightly against the output port of the valve, placing it in a "closed" state. The electrical signal of the pulse jet control device causes the electromagnetic pulse valve to move backwards, the vent hole in the rear chamber of the valve opens, the rear chamber rapidly loses pressure, the diaphragm component moves backwards, and compressed air is blown through the valve output port, in the "open" state. The electrical signal of the pulse jet controller disappears, and the submerged electromagnetic pulse valve resets. The vent hole in the rear chamber is closed, and the pressure in the rear chamber increases, causing the diaphragm component to tightly adhere to the output port of the valve and return to the "closed" state.

The pressure balance hole of CD-80 electromagnetic pulse valve is blocked The blockage of the pressure balance hole of the electromagnetic pulse valve is mainly caused by two reasons:

（1） Compressed air contains a lot of oil stains and water;

（2） When installing compressed air pipelines, foreign objects such as rust and welding slag inside the pipelines were not cleaned thoroughly.