Cement pole type testing equipment

NegotiableUpdate on 04/15

Model

Nature of the Manufacturer: Producers

Product Category

Place of Origin

Online Consult

Overview

The type testing equipment for cement electric poles is suitable for measuring the load characteristics and displacement changes of cement electric poles, and can be tested by third-party testing. There is one display window that can be configured with two force sensors and one displacement sensor The low tension shows 0.01KN, and the displacement measurement shows 1mm. Can display clearly under strong light. The product meets the testing requirements for load, deflection, and displacement of cement rods in GB/T4623-2014 "Mechanical Test Methods for Circular Cement Products".

Product Details

Cement pole type testing equipmentpurpose

Cement pole type testing equipmentIndicator functional conditions

1. Purpose: Measurement1Test within 00KN

Measurement: Winding type 12Displacement measurement within 00mm

(The smallest display unit is 1mm)
Force display unit
1At 00KN The reading is 0.1KN

1At 0KN The reading is 0.01KN

3. Displacement display unit in millimeters

4. Measurement accuracy　≤1% . Reading ± 1 word　

5. Force display adjustmentzeroZero adjustment

6. Zero adjustment of displacement display

7. Environmental temperature for use　-5℃ ～+45℃

8. Use environmental humidity　80% (relative humidity)

9. Power supply voltage range~220 ± 15% (50Hz)

10. There is no strong magnetic field around during use.

11. Allowable load error: 1%

usage method:

1. First, connect the selected load sensor to the "Force Signal Input" socket on the left side of the rear panel of the tester using a five core cable signal line10KN or1After zeroing, it displays 000KN

2. TakeTwist the displacement sensor and displacement signal line. The other end is connected to the socket on the back panel (displacement input) of the tester.

3. Connect the power socket to the rear panel of the tester（220V Power Supply）Plug in socket, withConnect the 220V power supply.

4.At this time, turn the zero knob of the two windows and adjust them to000
5The. 00mm displacement sensor should display as 000mm
6.Load window display readingThe 10KN sensor is 00.000KN

There should be a 15 minute warm-up process from startup to operation, and work should begin after the numbers have stabilized.