Corrosion resistant submersible pump

1、 Overview of corrosion-resistant submersible pump products: The corrosion-resistant submersible pump is made of stainless steel material (304, 316, 316L) precision cast as a whole. The pump outlet adopts a flange structure, and the motor is F-class insulated, suitable for applications that require frequent motor start-up. The impeller has a loosening device to prevent reverse rotation; The mechanical seal is made of corrosion-resistant fluorine rubber alloy material; The rotor shaft is made of stainless steel

1Corrosion resistant submersible pumpProduct Overview:

Corrosion resistant submersible pumpThe overall material is made of stainless steel（304、316The316L）Made by precision casting, the pump outlet adopts a flange structure, and the motor isFGrade insulation, suitable for applications where frequent motor start-up is required. The impeller has a relaxation device to prevent reverse rotation; The mechanical seal is made of corrosion-resistant fluorine rubber alloy material; The rotor shaft is made of stainless steel.

Corrosion resistant submersible pumpIt has the characteristics of high efficiency and energy saving, corrosion resistance, acid and alkali resistance, compact structure, beautiful appearance, convenient use, and long-term trouble free safe and reliable operation.

II Corrosion resistant submersible pumpPurpose:

Landscape fountain

Industrial water supply and drainage

Municipal construction engineering water supply and drainage

Agriculture and garden irrigation

three Corrosion resistant submersible pumpApplication conditions:

1The water pump should be used within the rated head range and fully submerged in water. The depth of immersion in water should not exceed3Rice, the deepest not exceeding5Rice. At the same time, the water pump should not sink into the mud, ensuring that it stays at the bottom of the water0.5Distance above meters

2Power requirement: frequency of50HZ, rated voltage380V(Allowable deviation of positive and negative5%）Three phase alternating current.

3Medium requirements: The volume ratio of sand content or solid particles insoluble in water shall not exceed0.1%The granularity is not greater than0.2mm

4Temperature of the conveying medium:-15Celsius~+40Celsius

5Range of acidity and alkalinity of the medium: ordinary pumpPH4~! 0

6Maximum operating altitude: not exceeding1000m

4The parameter range of corrosion-resistant submersible pumps:

Power:2.2-7.5KW

Caliber: 50-200mm

Flow rate: 15 cubic meters per hour -260 cubic meters per hour

Lift: 3.5-56 meters