Double layer slurry mixer electric mixing dry motor

Double layer slurry mixer electric mixing dry motorNon standard, various specifications of mechanical mixers can be customized according to user conditions such as water quality, water temperature, corrosiveness, viscosity, etc.

Among them, there are multiple options for reducers, including domestically produced ones, cycloidal needles, and gear reducers; The mixing rod and mixing blade are made of various materials such as stainless steel, carbon steel anti-corrosion, and plastic; There are multiple options for blade shapes, including two-page, three leaf, single-layer, double-layer, and frame style.

JBJ type paddle mixer is suitable for dilution, dissolution and mixing of various chemicals, as well as mixing and stirring in the coagulation process of water supply and drainage treatment.

Double layer slurry mixer electric mixing dry motorFeatures:

1. Simple construction, reliable operation, no blockage, and easy maintenance.

2. It can achieve a certain mixing intensity within the required mixing time, meet the requirements of fast, uniform, and sufficient mixing speed, and has low head loss. It can also adapt to changes in water volume and is suitable for water plants with various water volumes.

3. The slurry mixer has the advantages of low energy consumption, low noise, easy operation, fast discharge speed, long service life of lining plates and blades, and convenient maintenance.

4. The slurry mixer is suitable for mixing plastic, dry hard, lightweight aggregate concrete and various mortars and mortars.

Electrical control: Control box can be manually configured with PLC interface or configured according to user requirements.

Ordering instructions:

1. According to the user's size;

2. Indicate the main material, carbon steel or stainless steel;

3. When placing an order, relevant process, civil engineering information, and detailed technical requirements must be provided.

When the raw water and coagulant or coagulant aid liquid flow through the mixing tank, flow circulation is generated under the discharge of the mixer, allowing the coagulant to quickly and thoroughly mix with water to meet the requirements of the coagulation process.

Precautions for using a slurry mixer:

1. The mixer should be placed in a flat position, with square blocks used to support the front and rear axles, allowing the tires to rest on the rack to prevent movement during operation.

2. The mixer should be equipped with secondary leakage protection. After the power is turned on before going to work, it must be carefully inspected. Only after passing the empty test run can it be used. During the trial operation, it is necessary to check whether the mixing drum speed is appropriate. Generally, the speed of the empty truck is slightly higher than that of the loaded truck

Fast 2-3 revolutions per minute. If there is a significant difference, adjust the ratio between the driving wheel and the transmission wheel.

3. The rotation direction of the mixing drum should conform to the direction indicated by the arrow. If it does not match the actual direction, the motor wiring should be corrected.

4. Check whether the transmission clutch and brake are flexible and reliable, whether the steel wire rope is damaged, whether the track pulley is in good condition, whether there are obstacles around, and the lubrication condition of each part.

5. After starting up, regularly pay attention to whether the various components of the mixer are operating normally. When shutting down, regularly check whether the mixer blades are bent and whether the screws are loose or loose.

6. When the concrete mixing is completed or expected to stop for more than 1 hour, in addition to removing the remaining material, stones and clean water should be poured into the shaking drum, and the machine should be turned on to wash away the mortar stuck to the drum before discharging it completely. There should be no accumulated water inside the barrel to prevent rusting of the barrel and blades. At the same time, the accumulated dust outside the mixing drum should be cleaned to keep the machinery clean and intact.

7. After work and when the machine is not in use, the power should be turned off and the switch box should be locked to ensure safety.