High pressure vortex fan

High pressure vortex fan

Vortex air pump, high-pressure blower, air ring compressor, and side flow blower are a type of product that have dual functions. The same product has both suction and blowing functions, and can also use both suction and blowing functions simultaneously. Beautiful appearance, balanced operation, easy to use, and the fan blades are made of high-strength aluminum alloy; Compared to other fans, its pressure is much higher, with both dynamic and negative pressure often being more than ten times that of ordinary fans.

maintenance
The vortex air pump should be placed in a relatively stable place, and the surrounding environment should be clean, dry, and ventilated.
The rotation direction of the impeller of the vortex air pump must be in the direction indicated by the arrow on the fan casing.
The working pressure of the high-pressure vortex air pump should not exceed 8kPa during operation to avoid excessive heat generation and motor overcurrent that may cause damage to the air pump.
Except for the two bearings of the motor rotor, there is no direct contact friction in other parts of the vortex air pump. The installation method of bearings for this air pump is mainly divided into two categories. *The bearing at the end of the class air pump is installed in the pump body between the motor base and the impeller, and this type of air pump does not need to be lubricated normally. The bearings on the second type of air pump end are installed in the middle of the pump cover, and the bearings on this type of air pump end should be regularly lubricated with grease (7018 high-speed grease). Once a month, for air pumps that work continuously in three shifts, the refueling frequency should be increased. The maintenance and upkeep of the bearings on the motor and fan end of this type of air pump shall be in accordance with the * type of air pump.
The filter screens and noise reduction devices at both ends of the inlet and outlet should be cleaned in a timely manner according to the situation to avoid blockage and affect use.
The external connection of the inlet and outlet must be made using flexible hoses (such as rubber hoses, plastic spring hoses).
Replacement of bearings for vortex air pump: The replacement of bearings must be carried out by personnel familiar with repair work. First loosen the screws on the pump cover, and then disassemble the parts one by one according to the order shown in the diagram. The disassembled parts should be cleaned, and then assembled in reverse order. When disassembling, do not forcefully pry the impeller, use a roller to remove it, and do not miss the adjusting gasket to avoid affecting the clearance that has been adjusted before leaving the factory.
The high-pressure vortex air pump strictly prohibits solids, liquids, and corrosive gases from entering the pump body.

High pressure vortex fan

It is a universal gas source machine that can be used for blowing or inhaling, with high mechanical precision. The operating parts undergo extremely precise balance design, testing, and calibration of component strength and critical shaft speed. It is widely used in industry and agriculture, covering infrastructure construction, environmental protection industry, automobile industry, electroplating industry, aquaculture industry, industrial dust collection, packaging machinery industry, printing machinery industry, plastic industry, chemical industry, food, electrical and electronic industry, light industry and textile industry, shipbuilding and railway aerospace engineering. Jieming Blower has summarized the following selection criteria for annular blowers. Before selecting the blower. The variety, specifications, and special uses of various ventilation fans produced, as well as the research and promotion of new products in the market, should also fully consider environmental requirements in order to select the best fan. Choose ventilation fans for different purposes. Explosion proof ventilation fans should be selected if there is a need for transportation; Dust or coal powder ventilation fans should be selected for dust removal or coal powder transportation