Imported steam jet transfer pump heat pump

Imported steam jet transfer pump heat pumpalso known asSteam injector, siphon injectorSiphonsSteam jet heaterSteam Jet Heaters”. It is an injector that uses high-speed steam injection to draw water and transport it to a certain height, while also increasing the temperature of the water. It can also be used for circulating heating of water

Principle of imported steam jet conveying pump principle

Steam jet heat pump is a specialized equipment for increasing low-pressure steam pressure. The principle is to use high-pressure steam(Drive steam)The high-speed airflow generated by the jet increases the pressure and temperature of low-pressure steam or condensed water flash steam,And the pressure and temperature of high-pressure steam decrease. Thus, the pressure and temperature of low-pressure steam can be increased to meet the production process requirements,Achieve energy-saving goals

Imported steam jet transfer pump heat pumpspecially made Special manufacturing required

1Generally, design and manufacturing are carried out based on the customer's design conditions. (Because standardized products are limited in application and affect their effectiveness)

2Steam jet (delivery) pumps are usually made "adjustable"

3It is very good to install it on the outer wall of the water tank or water tank with a mixer

4For water circulation pipeline systems with relatively low flow rates, using high-speed steam injection to extract and circulate water, steam injection (delivery) pumps are suitable choices

5Joint adjustment type: A full-length core is installed in the center of the equipment, and the adjustment process not only changes the throat area of the nozzle, but also changes the nozzle and mixing area proportionally, and the length of the mixing chamber also changes accordingly. Due to the constant geometric ratio and maintaining a good stable state, the load can ensure a high injection coefficient from small to large, which can be simply understood as a "continuously variable transmission" method

6The throttle core is divided into two sections, one for adjusting the nozzle and the other for adjusting the throat area. When the pressure of the "all-weather" injector does not vary within a certain range, the injection effect is still very good, which provides the most critical installation layout diagram for the thermal electric decoupling work of large unitsInstallation layout

Installed on the outer wall of the water tank or in the pipeline system for circulating heated water

Steam jet (delivery) pumps are only suitable for situations where the water flow rate is relatively low and for situations where the saturated steam pressure is not very high. It is obvious that a large water flow rate leads to a large steam flow rate, which cannot solve the problem of steam jet noise

Installation and application methods Installation and application mode

1Vertically installed in large water tanks, includingOn the outer wall of the "sewage tank with mixer", the water, sewage, and slurry in the water tank (water tank) are repeatedly circulated and heated

2Installed in pipeline systems, it sucks and transports water. Or draw water while heating the water. Or achieve repeated circulation heating of water in the internal system of the pipeline

3Vertical installation is the main method, and sometimes horizontal installation can also be used