Jilin chlorine dioxide generator

Jilin chlorine dioxide generator

The chlorine dioxide generator metering pump adopts high-quality PVC pump head, which has good corrosion resistance to hydrochloric acid and sodium chlorate, ensuring the effective operation of the metering pump.

Being able to maintain a certain pressure at the outlet of the metering pump to ensure measurement accuracy. At the same time, it also prevents siphoning when the process pressure is lower than the suction pressure. During the discharge stroke of the pump, pressure acts on the diaphragm, lifting it away from the pump seat and allowing the measured material to pass through the back pressure valve. When the discharge flow rate decreases to zero (suction stroke), the diaphragm resets, isolating the low-pressure material between the pump outlet and the valve from the outside, thereby maintaining a constant pressure at the one-way valve at the pump outlet.

Jilin chlorine dioxide generator

Before installation, it is necessary to determine the specifications and parameters of the chlorine dioxide generator. Chlorine dioxide generators are mainly divided into electrolysis and chemical methods, and chemical methods are further divided into negative pressure and positive pressure. Currently, negative pressure chemical chlorine dioxide generators are mainly used in the market. So, I will mainly talk about the installation and commissioning methods of this equipment:
Firstly, the installation environment should have a dedicated disinfection equipment room with a 220V or 380V power supply, a 0.2-0.5Mpa power water source, and ventilation fans or windows;
Secondly, there are details. Negative pressure refers to the use of power water to form a negative pressure siphon through a water sprayer, which adds raw materials into the raw material bucket and siphons the generated chlorine dioxide generator disinfectant to the power water pipe and brings it to the disinfection pool to achieve the disinfection effect. In this way, connect the power water pipe to the pressure gauge and then connect the water injector to the disinfection tank. The water injector is connected to the raw material tank and the equipment discharge port, and the pipeline between the equipment is connected; Just connect the power supply below (because the computer control screen has been adjusted at the factory, it is generally not suitable to set it again).
after thatIt's debugging,firstFirst, add the raw materials to the raw material bucket. The second step is to fill the water tank with water. The third step is to turn on the power supply of the control screen, adjust the frequency of the metering pump, and then set the control mode to automatic operation