Jinan chlorine dioxide generator manufacturer

Jinan chlorine dioxide generator manufacturer

There are generally two types of chlorine dioxide generators: one is used to mix sodium chlorate and hydrochloric acid to prepare chlorine dioxide, and the other is used to dispense finished chlorine dioxide preparations, also known as chlorine dioxide dosing devices.

Jinan chlorine dioxide generator manufacturer

Attention should be paid to protection during the dosing process of chlorine dioxide generators. Chlorine dioxide has a stimulating odor at high concentrations, and excessive inhalation can cause headachesWait for symptoms, so during the medication process, it is important to wear a safety gas mask as much as possible. Also, if the raw materials used are hydrochloric acid and sodium chlorate (or a mixture of finished chlorine dioxide AB agents), it is important to note that the two agents should not come into direct contact.

1. First shipment2113Pre departure equipment must be added5261Sufficient clean water, strictly prohibit empty operation of the machine4102;
2. The metering pump should stop feeding, and1653The water jet continues to work for more than an hour to oxidize the dioxide inside the reactorlvqiFully evacuate the body to prevent gas from overflowing from the inlet pipe.
3. If the power water source suddenly stops running, the metering valve should be immediately closed.
4. Hydrochloric acid is a strong acid, and operators should wear protective gloves. The raw material NaCLO2 should not be stored together with various acidic substances and should be kept away from sources of fire.
5. The temperature controlled water tank of the equipment should be regularly replenished with water to prevent damage to the heater. The controller is equipped with a protective device. When the water level in the water tank is lower than the set value, the fault light on the control cabinet will light up and water should be replenished immediately.
6. Chlorine dioxide has strong oxidizing properties, and the soft plastic pipes of equipment are prone to aging and poorly sealed, so they should be regularly inspected and replaced.
7. Regularly clean the sediment in the reactor. If the liquid level displayed on the reaction level tube exceeds the normal limit, it indicates that there is too much sediment and should be washed immediately. And check the quality of the raw materials.
8. Attention should be paid to cleaning and unblocking when the raw materials are prone to blockage due to impurities.
9. The equipment is heated by a water bath. When the equipment is not in use, the heated water and reaction solution should be drained to prevent freezing and damage to the equipment when the temperature drops below 0 degrees. If the equipment is used intermittently, to prevent the heating water and reaction solution from freezing, the temperature control box can be kept working continuously.