Pneumatic Component Testing Institution Performance Testing Material Testing Center

Pneumatic Component Testing Institution Performance Testing Material Testing Center

The Clear Analysis Technology Research Institute can provide testing services related to pneumatic components, such as sealing testing, pressure strength testing, flow characteristic testing, material hardness testing, etc. It also provides CMA/CNAS qualification testing reports and has a well-equipped and strong project testing team.

Pneumatic component testing cycle

Within 7-10 working days after the sample is received (can be expedited), there may be changes based on the sample and its testing items/methods. Specific information needs to be consulted with the engineer.

Pneumatic component testing process

1. Communication requirements: Understand the items to be tested and determine the scope of testing;

2. Quotation: Provide a quotation based on the testing items and requirements;

3. Signing: Sign a contract and confidentiality agreement to begin testing;

4. Complete testing: The testing cycle may vary depending on the sample and its testing items/methods. Please consult a testing consultant for specific details;

5. Provide testing reports and provide post service;

Pneumatic component testing related projects

1. Sealing test: Leakage rate ≤ 3mL/min under static pressure of 0.1-1.6MPa

2. Pressure resistance test: 1.5 times the rated pressure for 3 minutes without deformation

3. Flow characteristic test: CV value/KV value measurement error ≤ 5%

4. Material hardness testing: Aluminum alloy shell HV ≥ 80, engineering plastic parts HRR ≥ 100

Scope of pneumatic component testing

1. Execution components: Linear cylinder (cylinder diameter Φ 12-200mm), swing cylinder (torque 5-500Nm)

2. Control components: solenoid valve (diameter DN1.6-25), proportional valve (response time ≤ 20ms)

3. Auxiliary components: PU trachea (inner diameter Φ 4-16mm), quick connector (working pressure 0.3-1MPa)

4. Filter elements: air filter (filtration accuracy 5-40 μ m), oil mist device (oil drop rate 5-50 drops/min)

Related standards for pneumatic component testing

1. MensorCPC8000 digital pressure calibrator (0-2MPa, accuracy 0.01% FS)

2. FestoSFAP flow characteristic test bench (CV value measurement range 0.01-15m/h)

3. Instron5982 universal material testing machine (load 100kN, displacement resolution 0.001mm)

4. KEYENCEVHX-7000 digital microscope (5000x magnification, surface defect analysis)

The above is an introduction to the testing of pneumatic components. The Clear Analysis Technology Research Institute is committed to providing technical services such as product research and development, component analysis, formula reduction, material chemical testing, industrial diagnostic failure analysis, simulation calculation testing, large-scale instrument testing, and reliability verification. If you have any testing needs, please feel free to consult.

Pneumatic Component Testing Institution Performance Testing Material Testing Center