Pool water disinfection electrolytic salt sodium hypochlorite generator

Pool water disinfection electrolytic salt sodium hypochlorite generator

Sodium hypochlorite generatorIt is a sodium hypochlorite solution generated by electrolyzing saltwater, which is produced as needed without any by-products and does not affect water quality safety.

With the improvement of introduced new technologies, sodium hypochlorite generators are unique in China, with high automation and novel appearance,High integration.

The process flow is that the salt dissolved raw water is softened and enters the salt dissolving tank, where the salt is dissolved in water to make saturated concentrated salt water. The concentrated salt water flows into the dilution salt water tank in an equal proportion to tap water and is diluted to3%-5%Diluted saltwater flows into the electrolytic cell by itself; The electrolytic cell produces sodium hypochlorite solution and a small amount of hydrogen gas from the electrolysis of saltwater; Hydrogen gas is discharged to the outside through the hydrogen exhaust device, and sodium hypochlorite solution flows into the storage tank. The metering pump sends the sodium hypochlorite solution to the disinfection treatment facility.

1Sodium hypochlorite generatorScale formation in electrolytic cell

Reason: Due to the high hardness of the water quality, a large amount of calcium and magnesium ions adhere to the electrode plate during the electrolysis process, causing scaling faults over time.

Solution: Regularly use a concentration of8%~10%Citric acid is used to acid wash the electrolytic plate, and timely rinsing after acid washing can delay the formation of scale.

2、 Power alarm and shutdown

Reason:Sodium hypochlorite generatorThe temperature of the electrolytic cell is too high, and the temperature of the power supply is also too high.

Solution: Check if the concentration of electrolytic diluted saltwater is within the normal range; The startup time is too long in hot weather; Check if the fan is functioning properly.

3、 After starting up, the flowmeter cannot be adjusted or cannot reach the rated flow rate

Reason:Sodium hypochlorite generatorThe salt pump is damaged, or there is air in the suction port of the salt pump, the soft water pump is damaged, or the liquid level in the soft water tank is low.

Solution: Stop the salt pump, pull out the hose from the top of the flow meter and blow it hard a few times to exhaust the air, then start the salt pump again; If the problem still cannot be solved, replace the salt pump. Replace the water pump and check if the water softener is working properly and if the inlet flow rate is normal.

4、 When the water temperature is too high(Exceeding the set value)When the temperature exceeds the set value and continues to rise.

Reason:Sodium hypochlorite generatorThe temperature probe is damaged or the condenser is not working.

Solution: Replace the temperature probe; Check if the power supply and setting parameters of the condenser are correct.

Pool water disinfection electrolytic salt sodium hypochlorite generator