Exhaust gas treatment equipment is mainly an environmental protection device that uses different process technologies to recover or remove harmful components that reduce exhaust emissions, in order to protect the environment and purify the air. Below, the editor will talk about the precautions to be taken when using waste gas treatment equipment in sewage treatment plants.
1. After the operation and delivery of the exhaust gas treatment equipment, the user unit should assign a dedicated person to keep and use it, conduct regular inspections, and if any abnormal noise or water leakage is found in the equipment, it should be stopped and repaired before it can be used.
2. The exhaust gas treatment equipment should be installed outdoors, and the water pump fan motor should be covered with a rain cover to prevent the motor from getting damp. Regardless of whether the exhaust gas purification treatment equipment is installed indoors or outdoors, if fiberglass or plastic fans are used, protective covers must be installed to prevent screws from loosening, bearings from being damaged, or debris from being sucked in, and impellers from being damaged, which may injure personnel and cause accidents.
3. Replacement and allocation of exhaust gas purification solution: The formula ratio of purification absorption solution is determined based on the different gas sources and concentrations of the user unit. After the equipment is debugged and accepted as qualified, the specific information will be provided to the user management personnel.
4. Before using the exhaust gas treatment equipment, it is necessary to check whether the pipeline valves of each system of the equipment are intact, whether the selection and ratio of the absorbent agent are correct, and if the absorbent does not meet the requirements, it should be replenished in a timely manner. When starting up, the water pump should be turned on for 3-5 minutes before turning on the fan. When shutting down this purification system, the fan should be turned off for 2-3 minutes before turning off the water pump. Do not turn it on randomly, otherwise it will burn out the motor, block the packing, and affect the purification effect.
5. The wiring between the fan and water pump for exhaust gas treatment and purification should not be tampered with casually. They should be turned correctly and not reversed, otherwise it will damage the motor and cause accidents.
The above are the precautions for using waste gas treatment equipment in sewage treatment plants. We hope it will be helpful to you. If you have any further questions, please feel free to contact us, and we will definitely provide you with satisfactory answers.