Zhongkebeite shares the issues that should be paid attention to during the use of air flotation machines!

About Us

Shandong Zhongkebeite Environmental Protection Equipment Co., Ltd

E-mail
zhongkebeite@163.com
Phone
13356363156
Address
No. 8358 Luhe Avenue, Zhucheng City, Shandong Province

Date: 2025-02-19Read: 22

　　1. The work that needs to be done before starting the air flotation machine:

Check the power circuit and perform a brief no-load operation to determine if the pump and air compressor are turning correctly,

Check for any noise or heating phenomenon, and jog the mixer after injecting clean water to determine if its direction of rotation is correct.

Jogging the floating slag collection reducer to observe whether its direction of rotation is correct, whether there is any collision or instability. If there is, it should be eliminated in a timely manner. Turn on the power switch of the dissolution machine and configure it according to the concentration requirements of the liquid medicine,

Stir until the concentration of the liquid is uniform, clean the air flotation machine thoroughly, and ensure that no foreign objects are left behind. Check if the connecting parts are loose and if the lubricating oil is injected into the rotating parts.

　　2. Attention should be paid to the following issues during the use of air flotation machines:

To ensure that the water level of the air flotation machine does not submerge the packing layer and is not lower than 0.6m, this is to avoid a large amount of undissolved air in the center, which affects the fluctuation effect.

If the water temperature inside the air flotation machine is low, increasing the dosage can be used to compensate for the decrease in the buoyancy performance of the air carrying flocs due to the increase in water viscosity, ensuring the quality of the effluent water; The air flotation machine is based on the flocculation of the reaction tank.

Adjust the dosage of coagulant in a timely manner based on changes in the floating slag and effluent quality in the separation zone of the air flotation tank; Regularly operate the slag scraper to remove floating slag and establish a slag scraping system that is in line with the actual situation,

When using an air flotation machine, it is important to understand its ability to remove dirt so that you can know how much area it can handle.

Last Article: Underground sewage treatment equipment has strong resistance to impact concentration and high treatment efficiency.

Next Article: Analysis of the causes of leakage in the dissolved air flotation machine shared by Zhongkebeite