0060D003BN4HC is suitable for hydraulic oil filter cartridges in construction machinery

Problems encountered during the installation of hydraulic oil filter element 0060D003BN4HC is suitable for hydraulic oil filter cartridges in construction machinery

We have various problems with hydraulic filter cartridges during use, and there may be noise when installing them. We may be familiar with this issue. When there is noise, the machine will start to hear strange things. What kind of situation is this? How to find the source of noise and solve the noise problem is the key, otherwise bigger problems may arise in later use. Not only that, but the answer to this series of problems is as follows: any mechanical equipment has a certain service life, and exceeding the specified service life will greatly reduce its work efficiency. The same goes for hydraulic filters. If you want to avoid problems, you must choose high-quality hydraulic filter products, otherwise it may even cause production losses, especially in filtration equipment: we all know that to ensure the normal operation of the engine, it is necessary to regularly clean or replace the hydraulic oil filter. Once the hydraulic oil filter is clogged, it will produce noise. How is this noise generated? When the filter is clogged, hydraulic oil dirt will cause the filter to become clogged, resulting in excessive pressure difference between the hydraulic oil filter and both sides, and the oil level will be in an unstable state. When the oil level changes, due to the negative impact of the hydraulic filter element being too large, it is easy for air to mix into the oil pipeline and then spread to the pump. When squeezed out, pneumatic noise will be generated

Steps for filtering hydraulic oil filter element

0060D003BN4HC is suitable for hydraulic oil filter cartridges in construction machinery

Hydraulic oil filtration 1. Before filtering hydraulic oil, all cylinders should be contracted to the bottom.

2. Use a filtering device to pump the hydraulic oil from the oil tank into a clean oil drum. The remaining oil at the bottom of the tank can be discharged through the drain port and filtered again. Use the filtered oil to flush out impurities at the bottom of the tank.

3. Then use a filtering device to draw the oil from the oil drum into the oil tank.

4. Run all motors in 10 gears for at least 30 seconds; Make the oil cylinder complete at least one extension and contraction. This can flush out most of the oil from the cylinder, motor, and oil pipe. 5. Repeat steps 1 to 3 again. Note:

Before filtering, it is necessary to check whether the hydraulic oil should be replaced. Generally, this can be determined by checking whether the oil has any odor, viscosity, and whether the time has been too long, such as exceeding 4000 hours.