3KWDIBT4 explosion-proof aluminum alloy high-pressure vortex air pump fan

3KWDIBT4 explosion-proof aluminum alloy high-pressure vortex air pump fan——Product Introduction

The filter bag is connected to the air inlet, and the solid is attached to the inner surface of the filter bag. The initially filtered air passes through the gaps of the filter bag and then undergoes secondary filtration by the filter element to meet the emission standards. The filtered air enters the exhaust duct through the exhaust port of the fan or air pump and is finally discharged into the workshop to reduce energy, especially heat loss. In order to ensure the normal operation and performance of the high-pressure suction fan, it is necessary to strengthen the maintenance of the high-pressure suction and supply fan. Regularly clean the interior of the high-pressure suction and supply fan according to the specific usage situation. Especially the accumulation of dust and dirt on the blades, and prevent rusting. The lubricating oil inside the bearing box should be replaced every six months under normal circumstances, except during machine maintenance. During operation, it is necessary to regularly check whether the bearing temperature is normal, and the bearing temperature should be less than 40 ℃. If any abnormal conditions are found during the start-up, shutdown, or operation of the high-pressure suction and supply fan, immediate maintenance should be carried out. To ensure personal safety, maintenance of high-pressure suction and supply fans must be carried out when parking.

Compared to centrifugal fans and medium pressure fans, its pressure is much higher, often more than ten times that of centrifugal fans. For example, there is a Jinnuoke high-pressure blower model 4HB630H67, which has an output pressure of up to 100KPA; If the pump body is die cast as a whole and shockproof mounting feet are used, the requirements for the installation foundation are also very low. It can even operate normally without fixing the feet, which is very convenient and saves installation costs and installation cycles; Compared to other types of fans, such as Roots blowers, their operating noise is lower, and the higher the power, the more obvious it is. It will be displayed above 5.5KW; Maintenance free use; Its consumable parts are only two bearings, which basically do not require maintenance within the warranty period; The mechanical wear of high-pressure blowers is very small because there are no other mechanical contact parts except for bearings, so the service life is naturally very long.

3KWDIBT4 explosion-proof aluminum alloy high-pressure vortex air pump fan