Corrosion resistant diaphragm pump

NegotiableUpdate on 05/06

Model

Nature of the Manufacturer: Producers

Product Category

Place of Origin

Online Consult

Overview

The high pressure of the fluid in the corrosion-resistant diaphragm pump may cause serious personal injury and property damage. Please do not perform any maintenance work on the pump and material pipe system while the pump is pressurized

Product Details

Corrosion resistant diaphragm pumpThe movement process of this product is: the motor output shaft drives the pump head active shaft to rotate, and the active shaft and the driven shaft in the gearbox are equipped with interlocking gears, thereby achieving synchronous reverse rotation of the active shaft and the driven shaft, and the rotor also rotates synchronously in reverse. The rotation of the rotor inside the pump chamber generates a continuous change in the volume of the medium, thereby creating a high vacuum degree and discharge pressure, achieving the transmission of the medium

Suitable for fluids with medium to high viscosity. The working point of a centrifugal pump is set based on water. If it is used for fluids with slightly higher viscosity, it is necessary to equip it with a reducer or frequency converter, which greatly increases the cost. The same applies to gear pumps.

Corrosion resistant diaphragm pump-Product features:

1: The valve ball is further processed by machine, with high roundness and improved sealing performance of the check valve.

2: The valve ball position is installed with four bolts, which has good sealing performance. The dry suction capacity of JOFEE pump can reach 4-7 meters

3: No lubrication required.

4: Guided air valve, with low air consumption and low daily use cost.

5: Easy to install

6: Small size, mobile instant noodles, can be used in various occasions

7: Easy to operate and maintain

When operating a pneumatic diaphragm pump, the following points should be noted:

1. Ensure that the maximum particles contained in the fluid do not exceed the maximum safe passing particle diameter standard of the pump.

2. The intake pressure should not exceed the maximum allowable working pressure of the pump. Compressed air above the rated pressure may cause personal injury, property damage, and damage to the performance of the pump.

3. Ensure that the pipeline system for pump pressure can withstand the maximum output pressure achieved, and guarantee the cleanliness and normal working conditions of the driving gas system.

4. Static sparks may cause explosions, resulting in personal injury accidents and property damage. Use wires with sufficient cross-sectional area as needed to properly and reliably ground the grounding screws on the pump.

5. The grounding requirements comply with local laws and regulations, as well as some special requirements on site.

6. Tighten the pump and all connecting pipe joints to prevent static sparks caused by vibration impact. Use anti-static hoses.

7. To periodically check and test the reliability of the grounding system, it is required that the grounding resistance be less than 100 ohms.

8. Maintain good exhaust and ventilation, and stay away from flammable, explosive, and heat sources.