Hyperbolic submersible mixer supply

Hyperbolic submersible mixer supplyHyperbolic mixer, as an efficient mixing equipment, is suitable for mixing and stirring various low viscosity liquids, solid-liquid, and gas-liquid mixtures; Not only suitable for circular and square pools, but also commonly used in rectangular pools for unit arrangement.

Among various existing sewage treatment processes, the pulsator mixer can mainly overcome the problems of blind spots in traditional blade (slurry) mixing and poor water gas mixing effect in aeration process, and play its advantage of uniform mixing. The main characteristics are manifested in the following aspects:

⑴ It can be used in various situations where liquids, solids, and gases are mixed, and can replace existing stirring equipment to achieve three-dimensional, spiral mixing, making stirring more uniform and improving stirring efficiency.

⑵ Large specific surface area impeller, large circulating water flow, small power configuration, low energy consumption, saving 30% -50% energy compared to traditional mixing methods.

The whole machine has a compact structure, reliable operation, and easy installation and maintenance.

The impeller is made of reinforced fibers or steel materials, which can adapt to different working conditions and have a long service life.

Hyperbolic submersible mixer supplyHyperbolic mixer device installation steps for hyperbolic mixer:

1. After a short period of time on the shore, observe the direction of impeller movement. When viewed from top to bottom, the correct direction of movement is counterclockwise rotation. If the opposite is true, switch the wiring positions of any two power supplies.

2. Separate and fix the motor cable from the sling, and never tie the cable steel rope together. To prevent steel ropes and cables from getting caught up in the impeller.

3. Use a crane to lift multiple curved surfaces and slowly place them in the designated position in the pool, being careful not to collide with the pool wall.

4. Secure one end of the fixed rope to the shore and connect the cable to the electrical control cabinet.

After the installation of the equipment is completed, a trial run must be conducted. Before trial operation, approximately 70% of the tank volume must be injected into the tank. Do not operate the equipment without water to prevent the mixing shaft from bending due to uneven force. Pay attention to checking after trial operation:

1. Check for any abnormal noise or temperature rise in the deceleration motor.

2. Is the motor current within the rated range (overcurrent is normal for a short period of time during startup)

3. The swinging situation of the mixing shaft.

4. Is there any debris in the pool.

In any of the above situations where abnormal phenomena occur, the cause must be identified and corrected before use.