Large kilogram level ozone generator

Parameters of air source ozone generator

The Guangzhou Shenghuan ozone generator system consists of a gas source system, an ozone generator, a power supply system, a cooling water systemPLCThe control system, ozone dosing system, and exhaust gas destruction system are composed of several parts.

After the air is compressed by a compressor (users with gas supply stations may not need an air compressor), the separator and first stage filter remove dust particles, water mist, and oil mist from the air. The cooler then performs shallow water removal to ensure that the water mist and oil mist content does not exceed0.01mg/m3Then enter the adsorption dryer for deep drying to achieve the required dew point of the gas source-40Below ℃, it is further removed by a Class II filter if it exceeds0.01Micro sized dust particles make the air level reach100Grade. Finally, nitrogen is removed through an adsorption oxygen generator to achieve an oxygen concentration of90%Above, it becomes a qualified raw material gas source.

The Shenghuan ozone generator uses air (or oxygen) as raw material, and when the current crosses a gap filled with gas, it discharges below the level of near ignition (breakdown) voltage when the voltage in this gap drops. During the breakdown process, the gas partially ionizes and becomes a distinctive diffuse light blue glow product, which is ozone. When using oxygen as raw material, the yield per unit area can be more than doubled.

Ozone discharge chamber (high)Boron titanium silicon material double gap inert discharge tube）

The purchase of high borosilicate discharge tubes for the discharge chamber of Guangzhou Shenghuan Ozone Generator is designed based on the required ozone production, which is determined by the total ozone production of a single discharge electrode under certain frequency and voltage gas source conditions. Therefore, the discharge electrode is the basic basis for the design of the discharge chamber, and the discharge electrode technology is an important part of the generator manufacturing technology. Therefore, in order to solve the problems of good heat dissipation, stable ozone production, long service life, and safe and reliable discharge body, we have chosen a specially designed double gap inert tube as the electrode tube, so that it will not be damaged for life. Adopting the most advanced honeycomb structure in Germany.

Ozone power supply device

The electricity generated by the ozone generator for producing ozone is provided by the power cabinet of the ozone system. The power cabinet of the ozone generator converts conventional voltage and frequency into the frequency and voltage required to generate ozone. The high-voltage power output from the power cabinet is connected to the high-voltage electrode of the ozone generator gas source inlet chamber through a special high-voltage cable and a specially designed high-voltage connector.

-The power cabinet applies power and electronic technology, and evaluates and develops technologies worth adopting at any time based on the development of global power electronics technology.

-Design, produce, and assemble a variable frequency inverter power supply system for ozone generators independently.

-The safety and reliability of power components are guaranteed by safe current and voltage.

-Using high powerIGBTModular switch components with complete protection functions.

-PWM centralized control technology and current sensorLEMSampling circuit, overcurrent, overvoltage, bridge arm interlock and other protection circuits.