Metal hump support

Kunshan Tianda Chemical Packing Co., LtdMetal hump supportIt is currently a high-performance and widely used support for granular fillers, widely used in fields such as oil refining, chemical engineering, fertilizers, ethylene, and oxygen production10Above meters, there are also bell jar type supports, corrugated mesh supports, grid type supports, etc.

The characteristics of camel hump support are:

（1）Hump support has good rigidity, allows for large loads, and can reliably withstand various pressures applied to it.

（2）Hump support has excellent fluid dynamics performance.

（3）Hump supported packing particles or fragments are less likely to block the orifice, for sizes smaller thanDN25The filling material can be first laid in one layer on the support plate300mmHigh large fillers, then stack small fillers.

（4）Hump support is lightweight and saves materials. It can be made of materials such as metal, plastic, ceramic, graphite, etc.

（5）Hump support unit combination structure, easy to install from manhole.

（6）The camel hump supports the three-dimensional structure of the support plate, which is conducive to increasing the opening area and making the opening area larger99.99%about. The principle of opening area is that the opening ratio must be greater than the void ratio of the packing layer, otherwise the support plate forms a "bottleneck" zone, reducing the tower load. The opening area is related to the structure, material, and tower diameter, and generally occupies a certain area of the tower section70%-99.99%For metal support plates99.99%左右。

Produced by Kunshan UniversityMetal hump supportHas excellent fluid mechanics performance, good rigidity, allows for large loads, and can reliably withstand various pressures applied to it. Filling particles or fragments are not easy to block the orifice, for sizes smaller thanDN25The filling material can be first laid in one layer on the support plate300mmHigh large fillers, then stack small fillers. Hump supports have the characteristics of light weight and material saving, and can be made of materials such as metal, plastic, ceramic, graphite, etc. The three-dimensional structure of the support plate is conducive to increasing the opening area, making the opening area larger99.99%about. The principle of opening area is that the opening ratio must be greater than the porosity of the packing layer, otherwise the support plate will form a bottleneck'To reduce the load on the tower, the opening area is related to the structure, material, and tower diameter, and generally occupies a certain area of the tower section70%-99.99%For metal support plates99.99%左右。

Installation requirements for hump support: Before installing the support plate, the surface of the support plate should be cleaned of oil and rust; The assembly positioning of the main support beam: The centerline of the beam should pass through the center of the cross-section of the tower at that location, and its deviation should not exceed ± 2mm; after the installation of the main support beam, its upper surface should be on the same horizontal plane as the upper surface of the support ring, and the horizontal deviation should be less than or equal to 2mm.