SDG50-009 Parallel Electric Cylinder

1electric cylinderPrecautions for use:
1. Servo electric cylinderIt is a precision mechatronics integrated product. Before use, it is necessary to read the usage precautions and related motor and driver manuals, and pay great attention to them during use. Unborn

The manufacturer is not allowed to dismantle the electric cylinder without permission, especially the screws outside the electric cylinder, otherwise the manufacturer will not be responsible
2.Servo electric cylinderIt is a basic maintenance free product, and any exchange of components must be carried out at the production plant or authorized location of the production plant Otherwise, the manufacturer will not be responsible
3. Motor andServo electric cylinderIt is connected by a high-strength synchronous belt and adjusted for tension. So the motor cannot be disassembled at will, otherwise it may cause damage to the synchronous belt due to improper tension.
4. installNever apply external torque to the piston rod to avoid damaging the electric cylinder
5. The servo electric cylinder adopts grease lubrication method, and there is a grease addition port on the cylinder body When adding, use Mobility SHC220 grease and grease gun, with a dosage and timing of 2 times（Gun range)/6 months (or 50 kilometers).
6.The oiling method for the screw nut is to extend the electric cylinder to its full stroke, stop the motor, and cut off the power supply Open the screw plug at the grease injection port of the screw rod on the cylinder barrel and use a dedicated oil gun to add oilOil. After refueling, install the plug, turn on the power, and travel back and forth 2-3 times throughout the entire journey.
When debugging the servo electric cylinder, it should be carried out at low speed first, and the speed should be increased after all aspects are normal to avoid damaging the electric cylinder
8.It is strictly prohibited to touch the sliding seat during product operation and maintain a safe working range.
When using ball screw products vertically, it is recommended to install a brake on the 'Z-axis' motor to prevent objects from falling off;

10.Resonance may occur when the effective travel is too large, and the maximum speed should be relatively reduced as the travel increases.

Production cycleAfter signing the contract and confirming the drawings, it will take approximately 3-5 weeks for the production cycle.