TANWELL sensor

代理 turck,AFM,hydrotechnik,bently,ai-tek,entek,mtl

The BENTLY 330750 design in the United States separates the speed probe from the signal processing circuit and connects it with a sturdy cable, allowing the speed probe to have a much wider temperature range than our other Velomitor sensors.

BENTLY 190501 from the United States is our low-frequency Velomitor sensor used for monitoring cooling towers with rotation speeds as low as 90 rpm

Functional Principle

Plug in flow sensors are based on the thermal principle. The measuring probe heats up by comparing with the temperature of the fluid medium, and when the fluid passes through the probe, it takes away some of the heat. The change in fluid flow rate is reflected by measuring the difference in resistance between these two thermistors. Turck wear-resistant thermal flow sensors can be used for flow rate monitoring of liquid or gas media.

Traffic alarm monitoring,

Used for matching flow sensors

IO link parameter setting, relay output

■Can be used for monitoring overspeed and underspeed values

TANWELL sensorIN081-T070-50，SK205-050-H020，SK081T-110-500， The change in fluid flow rate is reflected by measuring the difference in resistance between these two thermistors. Wear resistant thermal flow sensors can be used for monitoring the flow rate of liquid or gas media. High cost-effectiveness. The displacement monitor is a four channel monitor. It can accept non-contact sensor outputs, enabling it to calculate more than 14 key parameters for each channel. The module includes a built-in relay (expandable to five) and two 4-20mA outputs.

TANWELL sensorIN081-T070-50，SK205-050-H020，SK081T-110-500， The change in fluid flow rate is reflected by measuring the difference in resistance between these two thermistors. Wear resistant thermal flow sensors can be used for monitoring the flow rate of liquid or gas media. High cost-effectiveness. The displacement monitor is a four channel monitor. It can accept non-contact sensor outputs, enabling it to calculate more than 14 key parameters for each channel. The module includes a built-in relay (expandable to five) and two 4-20mA outputs.

■Linear monitoring

■Work range 0.06... 600000 mins-1

■Can connect 3 wires and comply with EN 60947-5-6 standard

NAMUR sensor, externally powered

■2 relay outputs and 1 transistor output

■Output current (0/4... 20 mA)

■pulse output

■Set parameters using FDT/DTM software via PC

Set, through the front panel or HART ®

■Intrinsic safety output circuit

Switch status indication

6 LED indicator light chains green/yellow/red

The light indicates the flow rate status

6 LED indicator light chains

Display: Flow rate below set value

LED indicator light red

Display: Flow rate is equal to the set value

LED indicator light yellow

Display: Flow rate higher than the set value

4-channel LED indicator light green

Installation method

Plug in sensor

scope of work

1…150cm/s

scope of work

3…300cm/s

Switch characteristics

typ. 8 s (2…15 s)

open time

typ. 2 s (1…15 s)

Close time

typ. 2 s (1…15 s)

Temperature gradient, response time

Big 12 seconds

temperature gradient

ð 250 K/min

medium temperature

-20…80 °C

Working Voltage

195…264VAC

Current loss

ð 30 mA

output performance

Relay output, complementary contacts

Rated working current

4 A

short circuit protection

No

AC switch voltage

250 VAC

DC switch voltage

60 VDC

Large AC switch capacity