Trendy smoke machine effect

As the tobacco purchase time approaches, tobacco farmers across the country are rushing to do the pre production work of tobacco leaves. As the tobacco leaves purchased by tobacco stations have certain standards, if they do not meet the requirements, tobacco stations may refuse to purchase, which is very unfavorable for tobacco farmers. Therefore, tobacco farmers pay more attention to the quality of tobacco leaves when making them.

So how can we improve the quality of tobacco leaves? If you want to make high-quality tobacco leaves, every step in the production process must be just right. Take tobacco as an example. After baking, the moisture content of tobacco leaves is very low, usually around 3% to 8%. Such tobacco leaves are easily broken and difficult to remove from the drying room. At this time, it is necessary to humidify the tobacco leaves to make them soft. Natural moisture regain can be used, but this method is not only uneven in moisture regain, but also more affected by weather and high air humidity. Conversely, the effect is worse and the time is unstable, which greatly affects the process of tobacco drying and the utilization rate of the drying room, causing a lot of economic losses for tobacco farmers. In order to improve the efficiency of tobacco production, most tobacco farmers now use tobacco humidifiers to accelerate the moisture regain of tobacco leaves.

The main function of a tobacco machine is to quickly increase air humidity, allowing tobacco leaves to achieve the desired moisture regain effect in a short period of time, saving time and improving the utilization rate of the kang room. It is very simple to use the wet flue gas machine in the kang room. After the kang room is turned off, when the temperature in the curing room drops to about 40 degrees, open the air inlet next to the boiler, place the spray tray at the air inlet next to the boiler, turn on the fan, adjust the time controller of the spray to 6-7 minutes on, and shut down for 3 minutes. After 1.5 hours to 2 hours, the tobacco leaves reach the state of "firm but not soft, and not broken", and the moisture has basically returned.

Trendy smoke machine effect

Product special performance:

1. The machine is equipped with a digital temperature and humidity control system, which can achieve humidity, time, manual, and remote control.

2. The machine has functions such as undervoltage protection, delay protection, water shortage and power-off protection, waterproof and moisture-proof fan, and separate control of atomizer by capacitor board.

3. The stainless steel water tank is sturdy and durable. During the use of the machine, the amount of spray can be increased and reduced according to the actual demand. The two water inlet modes are simple to install and use, and no special maintenance is required later.

4. Fast humidification speed, high efficiency, mist like water vapor, no water droplets, rapid humidification in a short period of time, no waste.

Trendy smoke machine effect The above is the relevant knowledge about tobacco leaf moisture regain shared by De Chengxin. We hope it is helpful to you!