Ingersoll Rand ARO Pneumatic Pump

Ingersoll Rand ARO Pneumatic PumpAdvantage:

1. Diaphragm pumps have a small volume, are easy to move, do not require a foundation, occupy minimal space, and are simple and economical to install. Can be used as a mobile material transport pump.

2. Diaphragm pumps can be used to transport fluids with relatively unstable chemical properties, such as photosensitive materials, flocculants, etc. This is due to the low shear force of the diaphragm pump, which has little physical impact on the data.

3. In the handling of hazardous and corrosive materials, diaphragm pumps can isolate the materials from the outside world.

4. Due to the use of air as a power source, the flow rate of diaphragm pumps is actively adjusted with changes in back pressure (outlet resistance), making them suitable for medium to high viscosity fluids. The operating point of a centrifugal pump is set based on water. If it is used for fluids with slightly higher viscosity, it requires a matching reducer or frequency converter, which greatly increases the cost. The same applies to gear pumps.

5. Diaphragm pumps are used in harsh construction sites, such as construction sites and industrial and mining wastewater discharge. Due to the high impurities and disorderly composition in the sewage, the pipelines are prone to blockage, which creates a high load on the electric pump and makes the motor vulnerable to heating. Pneumatic diaphragm pumps can pass particles and have adjustable flow rates. When the pipeline is blocked, they will automatically stop until clear flow.

6. Diaphragm pumps are reliable and cost-effective pneumatic pumps for use in flammable and explosive environments, such as fuel transportation. However, sparks cannot occur after grounding; Secondly, there is no heat generated during the homework, and the machine will not overheat; Thirdly, the fluid will not overheat due to the minimal agitation of the diaphragm pump on the fluid.

Ingersoll Rand ARO Pneumatic PumpInstallation:

1. Select a connection point for the inlet and outlet pipelines;

2. Each pump is equipped with a ventilation pipe, and the air pressure is set according to different pumping requirements;

3. The diaphragm pump is placed near the product;

4. Provide gas to the diaphragm pump by connecting the pump's inlet to a gas source with sufficient capacity and pressure to meet the requirements.

In step 3, connect the pump and pipeline with a hose. In step 4, Ingersoll Rand ARO diaphragm pumps are metal diaphragm pumps and plastic diaphragm pumps. It has the characteristics of easy installation and stress relief.

Advantages:

1. Spacious flow and good performance, allowing particles with a diameter of up to 10 millimeters to pass through. When pumping mud and impurities, there is minimal wear on the pump;

2. Ingersoll Rand ARO diaphragm pump does not require water injection, with a suction range of up to 5 meters, a head of 70 meters, and an outlet pressure of ≥ 7 bar

3. The Ingersoll Rand ARO diaphragm pump has no rotating parts or shaft seals. The medium pumped by the diaphragm is separated from the moving parts and workpiece medium of the pump, and the conveyed medium will not leak outward. So when pumping toxic, volatile or corrosive media, it will not cause environmental pollution and endanger personal safety;

4. The head and flow rate can be infinitely adjusted through the opening of the air valve (the air pressure can be adjusted between 1-7 bar)

5. Can work submerged in a medium