JJ-1J/J-1B electric mixer

The JJ-1J/J-1B electric mixer is widely used in various universities and colleges environment protection Research hygiene. Epidemic prevention Oil Metallurgy Chemical industry medical care. Textile and food unit laboratories. It is a commonly used tool by laboratory technicians.

Introduction:

　　JJ-1J/J-1B electric mixerWidely used in various universities and colleges environment protection Research hygiene. Epidemic prevention Oil Metallurgy Chemical industry medical care. Textile and food unit laboratories. It is a commonly used and effective tool for laboratory technicians.

II feature

This machine adopts mechanical timing. The motor uses a permanent magnet DC motor with high torque Stable rotational speed Continuous adjustable without noise and other advantages.

IIIJJ-1J/J-1B electric mixerPerformance:

1. Power supply: single-phase AC 50HZ 220V ± 10V

2. Motor power: 300W

3. Speed: 60~3000 revolutions per minute

4. Pre selection time: 0-120 minutes for self selection

Mixing capacity: 5-20 liters

4 Usage:

When using an electric mixer, first check if all the accessories are complete, then connect the two pillars in order and install them on the bottom seat (fixed with a wrench). Install the connector again and attach the fixture for holding the solution bottle. Check if the motor fixing rod is reliable. After installation, tighten and calibrate the mixing rod, and plug the motor power plug into the speed control box. Connect the power again and adjust the speed as needed.

Five Notes:

If it is found that the mixing is not concentric during use If the mixing head is unstable, please adjust the clamping head. If using a triangular bottle for mixing, first clamp the bottle mouth with a fixture, then align the mixing rod with the center, and then start the mixing machine. When using a large beaker, place it directly on the workbench.

2. If the power suddenly fails during use, please check if the fuse tube is burned out or check the power cord Is there any detachment of the power plug? If there are no such two reasons, please notify our factory for handling

3. This machine has mechanical timing control. If timing is not required during operation, please adjust the timing knob to the normally closed (ON) position. If timing is required, please adjust it to the desired time.

Containers smaller than ￠ 80 can be clamped on fixtures for mixing, while containers larger than ￠ 80 can be placed directly on the workbench. To avoid breakage caused by insufficient clamping.

To ensure safety, it is necessary to use a grounding wire to avoid accidents, and the instrument should be kept clean and dry

Mixing rods and support rods can be separately equipped according to requirements