The paper cutting machine equipment is equipped with a high-pressure blower

The paper cutting machine equipment is equipped with a high-pressure blower——Product Introduction

According to the centrifugal cycle principle, the high-pressure blower of B&R circulates and pressurizes the impeller in the air duct, generating high-pressure airflow as the impeller rotates. As a dual-purpose blowing and suction type, it can not only be used for blowing and conveying air for aeration, but also for air extraction and vacuum adsorption. Using an AC motor as the drive, the impeller is directly installed on the motor rotor, with a simple structure that can operate continuously with minimal maintenance.

Performance characteristics of Beijiale high-pressure blower:

1. Low noise: It uses a low-noise motor to operate directly, and the air inlet adopts a convergent streamlined vortex reduction form. In addition, an integrated sound suppression device is added to reduce the high noise of the B&R high-pressure blower, resulting in a low-noise effect.

2. Stable performance: The fan impeller adopts a front axle double bearing support structure for stable performance, and uses precision outer bearings with good heat dissipation. Therefore, it has the following characteristics: high-speed operation; The operating temperature of the bearing is low; Long service life of lubricating grease; Maintenance free.

3. Easy to install: Small and medium-sized fans are equipped with shock-absorbing mounting bases, while large fans are equipped with separate footrests for easy installation and use. They can be used for compressed air or vacuuming, and can also be installed horizontally or vertically.

4. Less oil and less pollution: When the impeller rotates, it hardly comes into contact with other parts except for the bearings, and the impeller does not need lubrication. The air chamber is clean, so there is less pollution.

5. High quality: processed by precision CNC machine tools, all copper coils, dynamic balance correction, combined with instrument testing, with quality requirements for the parts used. IP54 and F-class motors are used, with low noise and low failure rate. The motor and blower are separated by a shaft seal to prevent foreign objects from entering. At the same time, in order to protect users' convenience, the blower undergoes strict testing before leaving the factory.

Technical parameters of mechanical high-pressure blower:

功率： 0.4KW，0.4KW，0.55KW，0.75KW，1.1KW，1.3KW，1.6KW，2.2KW，3KW，4KW，5.5KW，7.5KW，8.5KW，11KW，12.5kw，15KW，18.5KW，20KW，25KW；

Type: Single blade fan, double blade fan, 2HB series B&R high-pressure blower, 4HB series B&R high-pressure blower;

Wind pressure: 50mbar-1040mbar;

Airflow: 80m3/h-2050m3/h (for the convenience of selecting different specifications, some commonly used single-stage/two-stage models are available in stock);

Frequency: 50HZ/60HZ Voltage: 110V-615V (other voltages can be customized if needed).

The selection of high-pressure blowers for B&R mainly considers three aspects: power, air volume and pressure (to be calculated), voltage, etc. The selection table for B&R high-pressure blowers is based on the operating characteristics, air volume, and pressure changes of B&R high-pressure blowers, providing selection data with high selection and use value. Generally, when selecting, we refer to the fan selection table, and find the point of the required air volume corresponding to the point of the required pressure, so as to obtain a cross point. Fans above the entire point usually meet the wind pressure and air volume requirements of your equipment.

Title of this article:The paper cutting machine equipment is equipped with a high-pressure blower