Carbon source mixing slurry mixer/device

Carbon source mixing slurry mixer/device

1Product Introduction:

The slurry mixer is currently the ideal model, with advantages such as high automation, good mixing quality, high efficiency, low energy consumption, low noise, easy operation, fast discharge speed, long service life of lining plates and blades, and convenient maintenance. The slurry mixer is suitable for mixing plastic, dry hard, lightweight aggregate concrete and various mortars and mortars.
Non standard, various specifications of mechanical mixers can be manufactured according to user conditions such as water quality, water temperature, corrosiveness, viscosity, etc.
Among them, there are various options for reducers, including domestic, imported, or cycloidal pin and gear reducers;
The mixing rod and mixing blade are made of various materials such as stainless steel, carbon steel anti-corrosion, and plastic;
There are multiple options for blade shapes, including two-page, three leaf, single-layer, double-layer, and frame style.

IICharacteristics and types:

1Simple construction, reliable operation, no blockage, and easy maintenance.

2It can meet the requirements of flocculation laws, making each section of the flocculation process have different stirring intensities, and can adapt to changes in water volume and temperature. Small head loss, simple pool structure, and convenient combination of external capacity.

3After setting the stepless speed regulation, the stirring intensity can be adjusted according to changes in water volume, raw water turbidity, and dosage, achieving satisfactory flocculation effect and saving the amount of chemicals used.

3、 Product advantages:

1. Simple construction, smooth and reliable operation, uniform mixing, no blockage, easy maintenance; It can achieve mixing intensity within the required mixing time, meet the requirements of fast, uniform, and sufficient mixing speed, and has low head loss. It can also adapt to changes in water volume and is suitable for water plants with various water volumes.

2. The whole machine adopts a motor-driven cycloidal pinwheel reducer for direct transmission, with a simple and compact structure, installed in the center of the water tank, smooth operation, and high dissolution efficiency.
3. Each mixer is equipped with a reducer, which adopts the K-H-V planetary transmission principle and a novel transmission mechanism combining short spoke cycloid teeth. This reducer has strong load-bearing capacity, high reduction ratio, high transmission efficiency, small volume, extremely low noise, and long service life. Within the operating range, the gearbox can operate continuously.

Carbon source mixing slurry mixer/device

4maintain:

1. The paddle mixing system requires maintenance personnel familiar with its structure and performance to regularly inspect and maintain the dosing mixer in order to ensure its long-term operation.

Before starting the paddle mixing system, oil must be added to the motor bearings, intermediate bearings, and gearbox. 2 # calcium lithium grease needs to be added to the motor bearings and intermediate bearings, and 30 # mechanical oil needs to be added to the gearbox, with the oil level reaching the center of the oil cup height.

3. Replace the lubricating oil for the motor bearings and intermediate bearings every six months (6 months) of operation. If the transmission oil is found to be lacking in the oil cup, lubricating oil should be replenished at any time. Every six months (6 months) of operation, all the oil in the transmission should be poured out and the lubricating oil should be replaced again.

4. Every year of operation of the gearbox, all lubricating oil inside the gearbox should be poured out and cleaned once with a cleaning agent. At the same time, check for severe wear and damage to the gears inside the gearbox. If necessary, replace the gears or gearbox.

5. Maintenance personnel need to regularly check the operation status. Check for any noise, overheating, or vibration exceeding the range of each bearing.