Lanjiang copper containing concrete tank slurry mixer

Lanjiang copper containing concrete tank slurry mixer

1Product Introduction:

The paddle mixer is currently the ideal model, with advantages such as high automation, good mixing quality, high efficiency, low energy consumption, low noise, easy operation, fast discharge speed, long service life of lining plates and blades, and convenient maintenance.

The paddle mixer is suitable for mixing plastic, dry hard, lightweight aggregate concrete, as well as various types of mortar and sand paddles.

IIMain technical parameters and installation dimensions：

IIIFeatures:

1Simple construction, reliable operation, no blockage, and easy maintenance.

2It can meet the requirements of flocculation laws, making each section of the flocculation process have different stirring intensities, and can adapt to changes in water volume and temperature. Small head loss, simple pool structure, and convenient combination of external capacity.

3After setting the stepless speed regulation, the stirring intensity can be adjusted according to changes in water volume, raw water turbidity, and dosage, achieving satisfactory flocculation effect and saving the amount of chemicals used.

Lanjiang copper containing concrete tank slurry mixer

4、 Maintenance:

1. The paddle mixing system requires maintenance personnel familiar with its structure and performance to regularly inspect and maintain the dosing mixer in order to ensure its long-term operation.

Before starting the paddle mixing system, oil must be added to the motor bearings, intermediate bearings, and gearbox. 2 # calcium lithium grease needs to be added to the motor bearings and intermediate bearings, and 30 # mechanical oil needs to be added to the gearbox, with the oil level reaching the center of the oil cup height.

3. Replace the lubricating oil for the motor bearings and intermediate bearings every six months (6 months) of operation. If the transmission oil is found to be lacking in the oil cup, lubricating oil should be replenished at any time. Every six months (6 months) of operation, all the oil in the transmission should be poured out and the lubricating oil should be replaced again.

4. Every year of operation of the gearbox, all lubricating oil inside the gearbox should be poured out and cleaned once with a cleaning agent. At the same time, check for severe wear and damage to the gears inside the gearbox. If necessary, replace the gears or gearbox.

5. Maintenance personnel need to regularly check the operation status. Are there any noise, overheating or vibration beyond the range of each bearing.