HZ-892A integrated vibration transmission

HZ-892A integrated vibration transmission

HZ-892A integrated vibration transmissionIt integrates vibration speed sensors, precision measurement circuits, and display circuits together to achieve the function of a traditional vibration measurement system that combines "sensors and transmission modules". It is suitable for building an economical high-precision vibration measurement system. This transmitter can be directly connected to DCS, PLC, or other systems and is an ideal choice for vibration measurement of factory equipment such as fans, pumps, motors, etc.
Installation position: vertically or horizontally installed on the measured vibration point, fixed with M10X1.5 screws at the bottom of the transmitter

Technical Specifications

2.1 Frequency response: 10-1000 Hz * or 5-1000 Hz (special instructions)2.2 Natural frequency: 10hz2.3 Measurement range: 0-20mm/s2.4 Output current: 4-20mA2.5 Output impedance: ≤ 500 Ω2.6 Working voltage: DC12-24V ± 10%2.7 Wiring method: 2-wire system2.7- Acceleration: 10g2.8 Measurement direction: horizontal or vertical2.9 Operating environment: Temperature -40 ℃~100 ℃, relative humidity ≤ 90%2.10 External dimensions: φ 34.1mm × 72.4mm2.11 Installation thread: m10 × 1.5 × 10mm (depth)2.12 Weight: Approximately 324g3. Installation3.1 Installation position: Install vertically or horizontally on the tested vibration point, fix the sensor bottom m10 × 1.5 × 10 screws on the tested housing, and then tighten the sensor on top.3.2 Installation dimensions and specifications: Refer to Figure 1. If the installation position of the transmitter is subject to high temperature steam erosion, protective measures need to be taken to reduce the ambient temperature of the transmitter. Generally, no protection is required.3.3 Wiring instructions: The brown wire is connected to the positive terminal of the DC24V power supply, and the blue wire is connected to the negative terminal of the DC24V power supply. At the same time, the brown and blue wires are also 4-20mA output leads. The connecting wires require good insulation performance and use two core shielded cables.