Quotation for Can Bottom Sampler

Quotation for Can Bottom Sampler

It refers to the under tank sampling facilities used for collecting oil samples, including sampling pipes and accessories located inside the tank, as well as the external parts of the tank (including connecting pipes, pumps, valves, etc.). This type of sampler is designed to meet the requirements of "automatic" or "semi-automatic" facilities that occur when oil sampling does not go up to the top of the tank. The tank bottom sampler mainly consists of an upper sampling tube, a middle sampling tube, a lower sampling tube, a float float ball, a flexible connecting tube, a manual pump, a ball substitute, a fixed frame, and a paving support.

feature

1. Suitable for oil sampling of light liquid petroleum product oil tanks such as gasoline, kerosene, diesel, jet fuel, naphtha, and benzene.

2. Take samples from three different height points of the oil in the tank, with the sampling points located at five sixth, half, and one sixth of the liquid level (or 250mm away from the bottom of the tank).

3. The main structure consists of three sampling tubes and one support tube (the support tube can also be a floating tube of a floating liquid outlet device, etc.).

4. The actual sampling point error and design error of using this type of tank sampler shall not exceed 5%.

5. The sampling diameter should not exceed 20mm.

6. Save sampling time and improve work efficiency.

Quotation for Can Bottom Sampleroperating steps

1. Clean and wipe the assembled sampler clean before use.

2. Insert the sampler into the liquid to be sampled, reach the depth, pull up the inner rod, and suck the liquid sample into the sampler.

3. After removing the sampler, push down the inner rod to transfer the sample and complete the sampling process.

4. After sampling, clean and wipe the sampler clean before storing it in a ventilated and dry place.

Specifications: Diameter 33mm, Length 800mm, 1000mm (can be customized according to user requirements)

Precautions

1. In order to ensure that the oil sample taken truly represents the oil product to be analyzed, the operator must first use a hand pump to drain the oil stored in the sampling tube (the required number of revolutions to operate the hand pump should be determined based on the displacement of the hand pump per revolution and the oil stored in the sampling tube), replace it with fresh oil (the same applies to pneumatic diaphragm pumps), and then sequentially open the sampling port valves for sampling.

2. The sampler is packaged and transported in sections. Attention should be paid to protecting the threads of each valve and sampling rod during on-site installation. During installation, first connect the sampling port connections, pay attention to the sealing of each connection part, and then connect the support pipes.

3. The inlet and outlet angles of the pump can be fine tuned, making it easy to install and adjust on site.

4. The material used for the equipment is determined by the user based on the actual working conditions.