Quotation for vortex blower

Quotation for vortex blowerCharacteristics of vortex blower:

1. It has dual functions of blowing and suction, and can be used for both suction and blowing;

2. Running with little or no oil, the output air is clean;

3. Compared to centrifugal fans and medium pressure fans, their pressure is much higher, often more than ten times that of centrifugal fans;

4. If the pump body is die cast as a whole and shockproof mounting feet are used, the requirements for the installation foundation are also very low. It can even operate normally without fixing the feet, which is very convenient and saves installation costs and installation cycles;

5. Compared to similar fans, its operating noise is lower

6. Maintenance free use; Its consumable parts are only two bearings, which basically do not require maintenance within the warranty period;

7. The mechanical wear of high-pressure fans is very small because there are no other mechanical contact parts besides the bearings, so the service life is naturally very long. As long as it is under normal operating conditions, 3-5 years is no problem;

Quotation for vortex blowerPrecautions before using vortex blower

Preparation and inspection before startup
1. Check if the bolts at each connection are loose.
2. Is the vibration system solenoid valve installed properly.
3. Is the air duct sealed.
4. Turn on the air source of the vibration system, check the pressure and whether there is any leakage.
2、 Activate the vibration system and fan
1. Activate the vibration system and observe if it is functioning properly.
2. Start the motor and observe if it is running normally and if there are any abnormalities.
3. Check if the wind direction is correct. If the wind direction is incorrect, please replace the motor phase sequence with relevant personnel.
4. Confirm again if the bolts at each connection are loose and if there are any abnormal sounds.
5. During operation, always pay attention to the operation of the dust removal fan and check for any abnormal sounds.
6. The dust removal fan can only operate after running for 5 minutes.