Stainless steel insulated pneumatic diaphragm pump

YKB-50PStainless steel insulated pneumatic diaphragm pump

YKB-50PStainless steel insulated pneumatic diaphragm pump

YKB Insulated Pneumatic Diaphragm Pumpinstall

1. Pneumatic diaphragm pumps generally experience vibration and require the installation of foot bolts.

2. If dirt enters the compressed air, it will affect the normal start of the pump. It is recommended that users install pneumatic triple fittings.

3. When replacing the diaphragm, it is necessary to clean the wrist connecting rod and lead sleeve inside the pump, and do not damage the white PTFE sealing ring. Install it as it is and it can be used.

4. When suctioning media that are prone to freezing, a valve should be installed at the inlet of the pump. When the pump is stopped, the valve should be closed first, and then the pump should be turned on for a few minutes until the medium in the pump body is completely drained to avoid difficulty in starting the pump again.

Characteristics of Pneumatic Diaphragm Pump

1. Spacious flow and good passing performance, allowing for particle diameters up to 10mm. When pumping mud and impurities, there is minimal wear on the pump;

2. The head and flow can be infinitely adjusted through the opening of the air valve (the air pressure can be adjusted between 1-7 bar):

3. The pump has no rotating parts, shaft seals, diaphragms, etc. The pumped medium is separated from the moving parts and workpiece medium of the pump, and the conveyed medium will not leak outward. So when pumping toxic, easily reactive or corrosive media, it will not cause environmental pollution and endanger personal safety;

4. Not powered. It is safe and reliable to use in flammable and explosive places.

5. Can work submerged in a medium:

6. The pump has a simple structure and few vulnerable parts. It is easy to install and maintain, and the medium transported by the pump does not come into contact with moving parts such as the valve and connecting rod. Unlike other types of pumps, the performance gradually decreases due to wear and tear of components such as rotors, pistons, gears, and blades

7. Easy to use, reliable in operation, and only requires simple opening and closing of the gas valve. Even if the pump runs without medium for a long time or suddenly stops due to unexpected situations, it will not be damaged. Once overloaded, the pump will automatically stop, with self-protection performance. When the load returns to normal, it can automatically start and run again;

8. Can transport viscous liquids (viscosity below 10000 centipoise):

9. This pump does not require oil lubrication and has no impact on the pump even when idling, which is the characteristic of this pump.

10. No need for irrigation. The suction lift can reach up to 5m, the head can reach 50m, and the outlet pressure is ≥ 6kgf/c ㎡.